Hole Size: 5/16"
Bit Style: A
Cut Length: 2 Inches
Recommended for all stocks, including plastics, foils, laminates, leather, chip board. The Teflon coating allows tool to move through stocks with minimum heat build-up. Provides a life 3x longer than drills without coating.
Style A will fit the following machines.
Superspeed
Casco
Challenge
Climax
Ottawa
Mark III & IV
Lassco-Spinnit
Rosback
NOTE: If you have a Challenge Model EH3A, EH3C, MS5 or MS10 this drill will not work. A 2-1/2 inch cut length is required. (Mfg P/N PD516PT-2)
