Replace your OEM back stop with this and run envelopes fast and smoothly - GUARANTEED! For A.B. Dick 350, 360, 9820, 9840, 9850, Ryobi, and Hamada...
This fully automated envelope feeder by Thompson can cut production time in half on envelope jobs. Feeds most all envelopes sizes, including 3x5",...
Run quality envelopes, use your old blankets! This special compressible packing was developed for just that purpose. Trim and adhere to back cylinder...
Produced by a former Kompac engineer. These fit, seal better, and last longer than the factory originals! They are made to replace the Kompac II...
MULTI-TASK STOCK CONVEYOR USE WITH ENVELOPE PRESSES - LABELERS - FOLDERS - TABBERS From press room to bindery, this versatile machine by Thompson...
This is a replacement clamp and screw for feed table on the A.B. Dick 360, 375 or 385 model press.
Molded plastic lower profile pile separator. It is 1 inch high at the heel, tapering gradually 7-1/2 inches to a sharp edge. A 3" width makes it...
Molded plastic standard profile pile separator. It is 1-3/8 inch high at the heel, tapering 6 inches to a sharp edge. Width is 3/4".
Molded plastic standard profile pile separator. It is 1inch high at the heel, tapering 5 inches to a sharp edge. Width is 1". This is a general use...